Guide
3000W Handheld Laser Welding and the FWH20-S10C 4-in-1 System: Full Specs
Full specifications of the 3000W handheld fiber welder and the FWH20-S10C swing head — welding, cutting, seam cleaning and remote cleaning in one unit, with a 7-inch HMI, double contact interlock and Bluetooth app.

Quick Answer: The 3000W handheld laser welder delivers high-power continuous laser for thicker plate and larger workpieces. Fitted with the FWH20-S10C 4-in-1 swing welding head, a single handheld unit can weld, cut, clean a seam and clean a surface from a distance, all controlled from a 7-inch TFT screen with Bluetooth app monitoring. 1. 3000W Handheld Welder Basics The machine provides 3000W continuous laser power, adjustable from 0% to 100%. A 10 m optical fiber carries the beam to the handheld head, the system is water-cooled, and it accepts either single-phase 220V or three-phase 380V supply. It welds stainless steel, aluminum, carbon steel, copper-plated sheet and most common metals, and the higher power budget is what allows deep penetration on thicker sections without pre-heating. 2. The 4-in-1 Welding Head: FWH20-S10C The FWH20-S10C swing head is rated up to 3000W at 1070 nm with a QBH interface, and it combines four functions in one body: welding, cutting, seam cleaning and remote cleaning. Seam cleaning width reaches 12 mm, and the cleaning module can be switched between 110 mm and 150 mm focus versions depending on how wide an area needs to be covered. An auto-swing function smooths the bead, spot diameter adjusts from 0 to 5 mm, focus adjusts from -10 to +10 mm, and assist gas pressure goes up to 1 MPa. 3. Control and Monitoring A 7-inch TFT touchscreen runs the welding system interface. Safety is handled by a double contact interlock: the laser only fires when the metal clamp is attached to the workpiece and the nozzle touches the part. Bluetooth app monitoring lets the operator check status and parameters without standing at the cabinet, which is useful when the head is working at the far end of a large frame. 4. Daily Use Notes Use distilled or pure water in the cooling circuit and replace it about every five months; add antifreeze in winter conditions. Argon, nitrogen or filtered compressed air can serve as shielding gas, selected by material. Keep the optics clean, check the protective lens regularly, and allow the system to cool between long production runs. The 4-in-1 head saves a tool change per part: prepare with cleaning, weld with the same body, then clean the seam without moving the machine. FAQ Q: What can the 4-in-1 head do besides welding? A: It switches between welding, cutting, seam cleaning and remote cleaning, so preparation, welding and post-weld cleanup are done with one head. Q: How does the double contact interlock work? A: The laser emits only when the metal clamp is attached to the workpiece and the nozzle touches the part, which prevents accidental firing. Q: What cooling water and gas should be used? A: Distilled or pure water, replaced about every five months, with antifreeze in cold conditions; argon, nitrogen or filtered compressed air as shielding gas.
